what is the difference between series and shunt compensation
using facts in a transmission line
Answer Posted / mirza
In series compensation voltage is injected into the transmission line while in shunt current is injected....
Is This Answer Correct ? | 6 Yes | 6 No |
Post New Answer View All Answers
how is working bearing heater?
WHY IL=IPH IN STAR AND WHY IPH=IL/1.732 IN DELTA? WHAT IS REASON BEHIND IT?
Difference between field rheostat and armature rheostat.
How you give clearance to a spare feeder.
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
What are the reasons for the parallel operation of transformers?
state the working principle of incondenscent tube?
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors
What are the causes for the failures of sandwich type (Al) busducts?
What is the RME and explain the full form and what is the RME work?
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to reconfirm its base capacity.
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
What is CVT and what is relation with wave trap?
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me