Interested to Buy Any Domain ? << Click Here >> for more details...
What is A check, B check, C Check & D check for a diesel
Generator? Please guide me as this question was asked many
times and till now i haven't get right answer.If you can mail
me then please mail me the answer @ yogiagarwal@gmail.com.
- 20 Answers
- 523824 Views
- Apollo Power, BDV, Bosch, Further Future, Honda, HVCC, Jackson, Kirloskar, Multi Arc, Ranbaxy, Regulus IMC, TVS, XCD, YWS, I also Faced
- E-Mail Answers
Answer Posted / mangesh pandagle
A-Check (Daily routein Check)
1. Check oil level.
2. Check cleanliness of DG
3. Check Battery Voltage
4. Check any Leakage
5. Check all filter condition
6. Check oil Level
7. Check coolent Level
8. Check Check V-Belt condition
B-Check (Every 300- 350 Hrs.)
1. Change oil.
2. Change oil filter,fuel filter,bypass filter.
3. Change Air Filter.
4. Change water Separator
5. Radiator cleaning with chamical
C-Check (Every 800-1500 Hrs.)
1. Change oil.
2. Change oil filter,fuel filter,bypass filter.
3. Change Air Filter.
4. Change water Separator
5. Radiator cleaning with chamical
6. Check All Electrical terminal & thimbles
7. Check polution level
D-check (Every 3000- 5000 Hrs.)
1. Complete DG set should be dismental.
2. Turbo charger service
3. Injector Pin service
4. Cylinder Head service
5. PT Pump sevice &
6. Repeat same B-Check process.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What are topping and superposed turbines?
How many lubricating holes are there in cylinder?
Explain how can I see where pipes are behind the wall?
What is the temperature at which diesel normally boils?
why we transfer FA(full arc) to PA(partial arc) in steam turbine at specified load?
Why do the radiators in your house click when you start the heating system?
If anybody have the ref. design book of the 3 point cylindrical rolling with sheet thickness of 2.3 mm & 67 mm internal diameter legth of 80 mm
How the analyses and calorific values of fuels can be reported ?
draw IRON-CARBON diagram.
What are the purposes of spiral gear in a purifier?
what is an intensifier?
We select 10mm nominal thickness for Elip head of a pressure vesel. The minimum thickness after forming is 8.2mm. (Shell thickness is 8mm. The minimum thickness after forming is satisfied or not with UG-79 (d)(3) in ASME SECTION VIII, Div.1?
How do you design a system which is required to experience a shock force of 15G in 10 milliseconds?
What is Lap welding?
fan having rotational motion why
