Interested to Buy Any Domain ? << Click Here >> for more details...
what is ifference between PFR ,MFR and batch reactor?
- 9 Answers
- 59965 Views
- BARC, IOCL, I also Faced
- E-Mail Answers
Answer Posted / vasista
but u will get same performance equations for batch and pfr why?
and batch reactors will have mean residence time and plug flow reactor has residence time why?
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Explain why is post-weld heat treatment (stress relieving) sometimes necessary for welded vessels?
The job profile as a Service Engineer?
Can condensate control in a reboiler cause water hammer problems?
how will we calculate the heat of formation through electron...??
How fouling effected the heat transfer rate?
Explain the working of a spray condenser?
How can you determine the largest impeller that a pump can handle?
Explain the reasons of removal of particles from effluent gas?
How can one determine the particle size distribution for a given bulk solid?
What are the factors involved in considering the choice of dry screw compressor?
MY generator water cooler inlet line height - 11 mtr inlet water line height - 7 mtr water come into the line from overhead tank, O/H tank height - 20 mtr the first tapping in the inlet line is 2" line which down to 4 mtr level plateform., second tapping in inlet water line goes to a pump 6" line installed at 4 mtr level plateform, pump capacity 200m3/hr, head- 30 mtr, hp-40. the outlet of pump of 6" water line connected to a header of 6 mtr long of 6" line, on this header the six tapping are connected, 4 nos. 3" line goes to 11 mtr height water cooler the pressure of the line is 0.15 to 0.25 kg/cm2, 2" and 4" pipe line connected to a cooler at 4 mtrlevel plateform. my question is, at 11 mtr height level the quantity of water and flow is not sufficient for my cooler, the temp. of cooler is rises much more. you are requested to suggest the modification of pipe line/ pump for take more water flow and pressure (desired pressure is 1 kg/cm2)
What are the assumptions made on conservation equation?
Where the Induced draft, forced draft & balanced draft furnace are to be used? Selection of furnaces are based on which criteria?
Why is post-weld heat treatment sometimes necessary for welded vessels?
how much maximum power can be generated by 320v, 10kg-cm synchronus motor if shaft is roteted mechanically at 50 to 60 rpm?
