Interested to Buy Any Domain ? << Click Here >> for more details...
Why selected cable colour red yellow and blue in 3 phase
Electrical system?
- 9 Answers
- 24846 Views
- Crompton Greaves, Essar, Gridco, I also Faced
- E-Mail Answers
Answer Posted / bharat b wankhade
Intensity is more and easily differential according to indian atmosphere.....
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
how i chosse capacitor bank if my energy meter is 48 kvr? tell me capacitor bank chossen formula?
Pleae send me last 5 years of Question book about RRB chennai.
what is rating boiler
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
how to control the speed to switched reluctance motor
dc supply given to dc generator winding.how is possible? my knowledge is saying the winding will burn. please reply.
what is rocking arrangement in arc heating
How can maintain our H.T. motors used in cement plant. please send me procedure.
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
Is the theorem applicable to ac sources?
why asa method ZPF method is more accurate than ASA method?
can we use ZNyn11 transformer instead of Dyn11 transformer in distribution for effectively eliminating harmonics from the industrial loads.
comparision between ACB and VCB
What do you mean by pull of electromagnet?
State Maximum Power Transfer theorem.
