Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate the CFM to TR?
What is the Formula
- 12 Answers
- 137642 Views
- Carrier, Voltas, I also Faced
- E-Mail Answers
Answer Posted / sid
1 TR = 400 CFM is a rough calculation used for the designing of duct used as a common rule....actually the cfm required to make 1 tr may vary according to the coil manufacturers.....so when designing duct using standards ,always check the cfm required to make 1 tr from the unit specifications.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
WHERE CAN I GET THE PREVIOUS QUESTION PAPERS OF Govt Polytechnic in deee 2nd year papers
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
what is the function of gss in the dg set.
cc of scorpio?
what is mean by dual digital protection in the relay field?
What are your future plans for the company if permanently employed?
does a DG set has low fault level as compared to that of a transformer.If yes then why.
How is operate breaker failure scheme in substation
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
How we can calculate the consumption in kwh of motor on basis of kw @100% load, @50% load & @ no load.
our industries ht line so power fluctation(once drop of power please rectify causes
what will happen if OLR CT in all phases are short circuted
