Interested to Buy Any Domain ? << Click Here >> for more details...
what is bus duct and what is differance between bus duct
and bus bar
- 6 Answers
- 49595 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashish malik
Bus duct are the hollow conductors used to transfer electrical power and used for high current .These are hollow because flow of the high current exhibits small amount of current passing through the middle of conductor due to skin effect . As to save conductor material and cost these are made to be hollow .
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Main advantage of auto transformer over two windings transformer is that A it needs no cooling B it uses only one winding C core losses are reduced D it has simple construction
Why line VTG = √3 phase VTG in star? How?
Can I use distributon class/transmission class Lightning arresots for protecting the building? If not why please explain?
distribution is maximum done by a)radial b)network c) parallel d)b & c
Electrical 'C' license full abbreviation , and full form
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
Describe the control mechanism of missile launcher???
Is it possible to protect 3phase overload and earth fault of the 3phase system using two CT's.
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
Which Class insulation is prefered for the sandwich Busducts ? Why?
what is difference between 2 pole structure and 4 pole structure in transformer yard
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Which type of transformer is used for lighting loads?
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
