Interested to Buy Any Domain ? << Click Here >> for more details...
why you have choosen civil engineering as a carrier ,what
goals do u have and how you wil aschiene it?
- 5 Answers
- 10654 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / basit jogilkar
This my father's dream that's why I'm choosing this
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is Short bored pile foundation.
What is the Roll of Water Bonding under VDF road?
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
Rate analysis of Vitrified tile in cement mortor 1:3
significance of specific surface area of particles?
what is the type of earthing
What is the general specifications of a bituminous pavement road?
How to compute minimum number of columns required for a site from area of site?
1.what is the mix proportion for cement soil compressed earth blocks? 2.how to calculate the mix proportion for cement stablised earth soil blocks?
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
At one time what is the height of Lift for concreting for Bridge Piers Class B Loading and refer the code.
How to fix the reinforcement in footing shorter bar at bottom and longer fix at top.
I am practising engineer. I am searching for tutorial of RCC T Girder design Example in staad pro.Do anybody has this?please help
For Granite Flooring,For Cement Slurry purpose which one is effective of cost control whether OPC or PPC or White cement?
