Interested to Buy Any Domain ? << Click Here >> for more details...
Why we apply 100ADC for contact resistance measurement?.If we apply AC what will happen
- 4 Answers
- 3967 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
DC measures only resistance not the impedance like AC
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
what is servo motor & how does it work.
Hi.. I am a BE GRaduate in E&E. I have 8.5 Experience in Tendering & Estimation field. I have done SAP SD course few years back. But due to some reason i failed to get job in that field and continued my own field. Now I am thinking of changing into SAP seriously. How should i go ahead???
DG cranking voltage?
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details
can mini-curcuit supply MIL-tested transformer !
How the PF control while running DG set with load
What is the drawback of class b amplifier?
How to calculate per unit impedance of transformer?
Can anybody please refer the best and simple book for about Protection relays and in detail of all its protection ?
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
the typical output of a solar cell is........
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
dg earth connect only in the amf panel or not why
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
