difference between accuracy and precision
- 6 Answers
- 6402 Views
- Honeywell, ONGC, I also Faced
- E-Mail Answers
Answer Posted / uday
Accuracy refers to the closeness of a measured value to a standard or known value.
Precision refers to the closeness of two or more measurements to each other.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why do we floating DC in DC system.
give eg of how I/P is used in control loops
what are the values of fuel flow rate in various places in boiler.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
how u choose thermowell lenght n pnumatic C/v size?
how to tune siemens sipart electro pneumatic positioner..plz tel me..
is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?
What is super thermocoupal?
what is isloted barrier how it works and what are the main purpose.how it make safe area.
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
What are different type of instrument cable
Explain the difference between plc and cnc?
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
