Interested to Buy Any Domain ? << Click Here >> for more details...
Why selected cable colour red yellow and blue in 3 phase
Electrical system?
- 9 Answers
- 24249 Views
- Crompton Greaves, Essar, Gridco, I also Faced
- E-Mail Answers
Answer Posted / pawan singh chauhan
AC three phase system colors {red,yellow,blue + green for earth} based on IEC(International Electrotechnical Commission)and NEC(The National Electricity Code)
because these colors are universal in india & easily detected if cables are heated
For DC system wire colors { Brown,White,Grey,orange} also based on IEC(International Electrotechnical Commission)and NEC(The National Electricity Code)
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
explain all the classes with example
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.
What is synchro?
defult setting in p220 micom motor proction relay for 11kv,640kw,f.l.a.-40a,1440rpm ht motor?
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
what is differnce btwen lll and lllg faults
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
Why control of DC motor is simpler?
What is the current carrying capacity of 0SWG,3SWG,10 & 12 SWG solid bare overhead copper conductors?
while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?
can anyone provide me a amf panel control wiring using ec-2 relay?
What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer
What test must you do before powering up a circuit that you have been working on?
