Interested to Buy Any Domain ? << Click Here >> for more details...
How to select the ratio of neutral ct? Is there any relation in between percentage impedance and neutral ct ratio ?
- 1 Answers
- 2724 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
It should be equal to that of line CTs ,with same magnetic characteristics if you are employing REFR
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what will happen if OLR CT in all phases are short circuted
How do we calculate over and under frequency tolerance from generator data?
What are the protections for safe running of electric generator?
how to identify conection leads of an unknown electric motor
How to work definite,over pluxing,revers power,OSR relay
advantage and disadvantage of team work?
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
what is the formula for efficiency of francis turbine and generator for hydropower? what is best way to select francis turbine and generator?
why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
how to read idmt curva
hai friends i have BSNL JTO exam on next month so if any body have model question paper or give preparation tips to my mail id kumar4486@yahoo.co.in this will helpfull for my future .plz & thank u by kumar
Why you are switching off arc protection mcb when you are taking shutdown for lv board.
What are the advantages and disadvantages of closed-loop control system?
