Interested to Buy Any Domain ? << Click Here >> for more details...
Actually why the transformers are rated in KVA.?
- 4 Answers
- 6108 Views
- BSL, Engineering, I also Faced
- E-Mail Answers
Answer Posted / pradyumna171
Transformer gives apparent power,it is the supply power to load and the power actually used by the load is the real power/true power/active power. Apparent power of 100 KVA has capacity to give 100 KW resistive load and for inductive load of o.8 pf it give 80 KW,and at 0.7 pf the same has capacity to give 70 KW . but the manufacturing company does not know which type of load to be connected across the transformer,therefore in simple we can say " DUE TO UNKNOWN POWER FACTOR THE TRANSFORMER ARE RATED IN KVA" and it is meaning less discuss about Iron loss & copper loss because the Inverted and UPS are rated in KVA but there is no iron loss & copper loss And in other hand in DC Generator there is Iron loss &copper loss but it is rated in KW not in KVA, because there is no angle between current and voltage(pf) in DC supply N:B . Transformer capacity -transformer iron loss & copper loss = transformer efficiency in KVA
PRADYUMNA PANDA BRG
Mob No. 9437917849
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
Explain Continuous and Discrete signals?
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
what are the ''pitting rings''and how cn they be controlled in a series generator
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
What is the working principle of servo motor? And explain it.
why occ characteristics of generator is also called as magnatization characteristics ?
In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..
what is the difference between the characteristics of two different phase bushing of any transformer
WHAT IS THE PARTIAL DISCHARGE TEST?
Why use the vcb at high transmission system ? Why can’t use acb?
What is sink and source?
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
