Interested to Buy Any Domain ? << Click Here >> for more details...
what is start up vent valve ? why it is used in boiler?
- 8 Answers
- 51753 Views
- ACC, Bhushan Power Steel, I also Faced
- E-Mail Answers
Answer Posted / swapnil raut
To take out non condensible gases out of boiler
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
What are different types of cable?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What are the type of bonnets in the control valves?
How to calculate P,I&D value in PID controller ?
Hi, I am Newely Joined in Construction company instrument engineer? Any one can Plz tell me How can I advanced preparation for Releated Engineering and construction Documents?
There are many type of control cable like pair,core,tried, What are defination each one
Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?
How to control flow variations in magnetic flow maters..... When i will provide proper earthing?
what is a half wave, full wave, and bridge rectifer.
How to calibrate H2s Dectector
How to fix back the valve actuator stem
why orfice is not used for main steam flow calculation
If P will increase then what will happen with PID?
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
What is the purpose of the analyzer in petrochemical plant?
