Interested to Buy Any Domain ? << Click Here >> for more details...
what is bus duct and what is differance between bus duct
and bus bar
- 6 Answers
- 49575 Views
- I also Faced
- E-Mail Answers
Answer Posted / thiag
Busbar:
Its the rigid conductor used inside the electrical panel for distribution of electrical supply inside electrical panel between incoming circuit breaker to outgoing circuit breaker.
Bus duct:
Its also a rigid conductor used to transfer electrical power from one electrical panel to another electrical panel. Busduct is used where there is a large amount of current transfer(approx 400A +)required.It shall used instead of cables.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
What is the implications when 600 hp motor is started when the unit is running with Transformer of capacity 1500 KVA and DG set of 1000kva
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors
why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
Main advantage of auto transformer over two windings transformer is that A it needs no cooling B it uses only one winding C core losses are reduced D it has simple construction
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
WHY DO VOLTAGE TRANSFORMERS FAIL DURING EARTH FAULT IN THE DELTA CONNECTED 6.6KV ELECTRICAL SYSTEM
what is the purpose of high speed earth switch in gas insulated substat
If any cable burnt how can we identify it burnt by high current of high voltage?
what type of questions are asked and howmwny questions belong this catagory?
how line turns ratio changes in 3 phase with change in connection
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
What is Plank's Law?
What is the reason for using a GE G101 MCB in place of an EP102 MCB if both are capable of AC circuit protection?
While testing a ZCT what parameters have to check or measure?
i applied for the ap transco please forward the freqventley asked QA
