when the motor was star position that is running ok but when
the motor was delta it was tripped? why?
Answer Posted / naveen joshi
There are many reason whether resistance increased by terminal contact in motor or phase difference in roter and stator not matched during transition from star to delta , increase the pause timing in timer .
.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
What are the protections for safe running of electric generator?
1. Design a counter which counts 0, 4, 8, 2, 6, and repeats using: 1.a using JK flip flops 1.b using T flip flops 1.c using D flip flops
How can we findout the maximum efficiancy of Transformer? At which load?
is the value of inductance depends upon the evalue of thitha in doubly excited machine?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
Differentiate between kirchhoff’s first law and kirchhoff’s second law?
can u tell me the promotion from oiller to enginer
how can we calculate the ratio of caustic soda and water in lrs.
what is the importance of earthing system on the generators big capacity and small?
Logic using 1 kV or 1,1 kV grade in house wiring Low voltage cable. Explain/suggest? some use 1kV and some prefer 1.1kV grade insulation low voltage cable why??
What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer
Please define ohm’s law for a.c (alternating current)?