Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / jithendra adusumilli
all the controls (VCB's & protections relay) will be on DC
When the AC supply is off then for identification of the VCB's & control will very easy it means heart of the Control
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how dose servo motor works
In synchronization circuit what is the function of Interposing voltage transformer(IVT)and Reverse voltage transformer(RVT)
How much pf maintan in dg set in 6o% load,when Dg runnig Neutaal Earthing removed what happen.
How can I known multiplying factor .without multiplying table
How to calculate the time setting for star connection in star delta starter? For example 10KW 3PH Induction motor.
How to Calculate The sag of OPGW in Transmission Line???
PAC and simple Ac different
How can i calculate the Breaking capacity of molded case circuit breaker, is the breaking capacity of CB for Diesel generator shall be less than grid supply's breaker ?
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
The windings of a transformer are divided into several coils, because?
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
Are Refrigerators & Deep Freezers the Inductive load ? How to calculate the Power Factor & hence the Output Power for them ?
How to calculate that clean water supply in one Day from 150 KLD STP?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
Write down the brushes of a de machine.
