Interested to Buy Any Domain ? << Click Here >> for more details...
when we connect a ceiling fan to a inverter's output
voltage, it give some noise, why?
- 5 Answers
- 12311 Views
- Luminous, I also Faced
- E-Mail Answers
Answer Posted / vinodkumarkkp
When dc to ac is converted , it is 12 v ac and t/f step up and due to this t/f does not step upto 220 v ,i.e. Nearby 220 v it is stepped up . But fans are not working properly below 220 volts a.c. I think this is also a reason.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
which pump used in STP
Is there any Institution for giving M-tech in Electrical engineering for those who r in service? Give the details please.
electrical
What is tranformer differtial?
Which is the oldest hydropower plant in india?
how we can calcultae the short circuit level for bus bar
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
Explain what is use of lockout relay in ht voltage?
Salient pole alternator is more stable, why?
what is the difference between 50 hz freq. and 60 hz freq.? which is better and economic in them ?
EXPLAIN THE TERMS "INTEREST AND DEPRECIATION" AS APPLIED TO ECONOMICS OF POWER GENERATION.
What is the basic rule for block diagram reduction technique?
I need HT sphere gap calibration table. Can any body help me.
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
what is different between phase and netural
