Interested to Buy Any Domain ? << Click Here >> for more details...
If the design CBR of subgrade is 10% but the material available on site is 30%.will you compact less(like 90%) where you get desirable CBR(10%).
- 3 Answers
- 6275 Views
- I also Faced
- E-Mail Answers
Answer Posted / rk
For increase the cbr must be added bending material like sand and granular particals for making proper cbr.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the diff b/w ROAD TUNNEL & RAILWAY TUNNEL ??
Any strength is a stress but any stress is not strength
1.what type of the rock is most suitable for wet mix macadam in construction of road? 2.what is the highest maximum dry density and optimum moisture content can be acheive by using most suitable crush rock?
SAND AND STONE AGGREGATES WASTAGE PERCENTAGE IN CONCRETING WORK?
Can you pl explain the procedure steps of singly and doubly reinforced beams in limit state method
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
I am a civil engineering student and going to attend interview in this week in an IT company.Will they ask me questions about my area of interest or cs
How to calculate density of 40 mm coarse aggregate, in mixing ration 1:1.5:3? Please explain calculation for density
in design case of structural member best suitrable percentage of steel limit is what
How do you change a dimension value in solidsworks?
what r the precaution for high in atp tempareture,low in atp tempareture
What out turn civil works
What is high adherence steel bar? I have a general specification which refers to High Adherence steel bars, coils and meshes to BS EN 10080 and BS 4449 or BS 4483. Is this just general re-bar or is there something different about it? The spec originated in France.
How do You Maintain a structure after getting cube test of low strength.
How to find the cuplock pipe qty in staging for Minor bridge?
