why fault current time duration is calculated for 1 minutes?
Answer Posted / perladel
I think there is a mistake it shoud be 1 second, 1 mitutes fault is a disaster due to thermal force develoment
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
11 kv input, 66 kv input advantages
why industry prefer ht motor instead of lt motor.
block diagram of 2 ups system connected in hot stand by mode?
Why do we use copper cable for HT Supply and why not Aluminium?
What are gain margin and phase margin?
in science exhibition how lamp can blink when you clap near the lamp ? thank you
How are load losses and no-load losses measured at site in a DG set?
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection
If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.
Why an ac solenoid valve attract the plunger even though we interchanges the terminal? Will the poles changes?
What Should be the value of Vector Surge angle at Tripping and how to calculate it?
A cotter joint is generally used to transmit
what is feeder bay?
what is the most permissible winding temp when we conducting a generator load test?(condition no load)