how much cement is required for 100 sft plastering of ratio
1:4
Answer Posted / qudrat
what is the cost of cement for plaster 2'' for the ratio of 1 to 4
Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
Providing ,Cutting, bending and positioning of TMT Bar with cost of binding wire
do we decide reinforcement steel , based on bending moment ? give example with continous slab?
what is the formula for Mass of cement grout (Dg)=???
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
How will you Engage Labours on Site?
what is the specific gravity of rubble in plum concert
Rate analysis of Vitrified tile in cement mortor 1:3
a solid steel rod length 2m dia and 20mm vertically hangs from celling and has a collar firmly atteched to it. above the collar an annular rubber washer of 40mm th. having stifness k = 5n/mm is placed. determine maximum stress in the rod caused by mass of 5 kg falling through a height of 1.2m.
we want build 10ft height ,tostore 4 litresof water.what is theground basement for steel andcement andsand.please send us basment calculation?
In a beam,stirrups are placed closely at ends than at centre due to shear.similarly where would ties be closer to each other-at center or at ends in a column and slab.
Which condition will prevail for the design of a swimming pool ? When the pool is empty or when it is filled ?
In Residential home construct footing,beam, column,lintel,rcc roofs which dia rod used how to self assumed
How much quantity of rod binding work by a rod binder per day
What is a bearing capacity of soil?
what might be the problem faced in the near future if the M-sand is used in the place of river sand during wall plastering? (As per IS)