Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nishat
flow is directionally proportionalto suare root of differencitial pressure
f=square root(p1 - p2)
so suare root extractor is used to solve the square root so that we could get correct flow
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
In which principles tx ,pressure gauge,Temp gauge,control valve works?
Explain why use mmwc unit?
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
How to decrease opening & closing time of on/off valve?
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
How it the difference between force balance system and dispalacement balance system?
What is the PLC configuration in Cement industry?
can u briefly explain aboutan aryton shunt multirange DC ammeter?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
typical loop drawing of a simple feedback control comprising of one transmitter and one control
What is voltage regulator?
What is stripper & spilitter ? Diffrence in this.?
Why the ammonia and Nitric Acid level indicators is with millimeter ? and What is the conversion form millimeters that level indicator indicate to weight ?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
