How much energy save vfd if motor run on 50 Hz (full speed)
Answer Posted / nagaraj
VFD stands for variable frequency drive.Change in frequency changes the RPM , which is directly proportional.
Synchronous speed = 120 x f/p
Here 120 is constant, f stands for frequency and p for no. of poles. The operating frequency in INDIA is 50 Hz.
Operating frequency is set at 50Hz, motor runs at rated speed, so no savings in power consumption.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
determine two methods to find loose connection in operational electrical system?
State angle criterion.
What is phase cross over frequency?
What is Harmonics how it is produced and what is the method to control the same
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
An ISP is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute these blocks to 2600 customers as follows. a) 200 medium size businesses; each needs 16 addresses b) 400 small businesses; each needs 8 addresses c) 2000 households; each needs 4 addresses Design the subblocks and give the slash notation for each subblock. Find out how many addresses are still available after these allocations.
Define conversion efficiency of a power amplifier.
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
what is the difference between surge protection capacitor and surge arrestor
Application Comparison between 22KV (UE)and 33KV (E) system. Are we allowed to use 33KV (E) cable in lieu of 22KV (UE) cable. What are the technical disadvantages.
detailed procedure how we calculate cost for pcc m10 and rcc m20 including centering and labour excluding steel/ iron
What is meant by coupling capacitor?
The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input
What is use of starter and choke in tube light
why the rotor current becomes in steady state during high slip region? please verify with equations.