Interested to Buy Any Domain ? << Click Here >> for more details...
if a 3 point starter is not available, how can a dc motor be
started?
- 3 Answers
- 21134 Views
- Accenture, BIT, Techno Solutions, I also Faced
- E-Mail Answers
Answer Posted / dhavalb
rheostat connected in series field winding perfect rating
| Is This Answer Correct ? | 12 Yes | 4 No |
Post New Answer View All Answers
Why AC & DC capacitor are use in UPS ??????????????????
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
What do you mean by lighting transformer?
block diagram of 2 ups system connected in parallel mode?
which pump used in WTP explain the function of VFD how to dtermine capacitorbank of capacity one plant
What are the differences between single phase and three phase?
What Maximam Gap Taibaar & Bush
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
Should power factor be low or high?
What is the difference between DOL starter and star delta starter
FOR 16/20 MVA 132/33 KV ONAN/ONAF TYPE TRANSFORMER IT IS DESIGNED FOR 16 MVA WITH ONAN CONDITION.IT BECOMES 20 MVA UNDER ONAF CONDITION.LOAD LOSS IS GUARANTEED FOR 65KW AT 20 MVA AND % IMPEDANCE 13.75. PLEASE TELL US AT WHAT LOAD LOSS AND % IMPEDANCE IT SHOULD BE DESIGNED FOR 16 MVA AND WHAT WILL BE ITS EFFICIENCY AT 20 MVA?
What is essential to prove safe isolation of electrical circuit?
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
What happens to a line-frequency of high-frequency transformer when it is first energized/ re-energize?
how to calculate slip ring induction motor stator and rotor currents??
