How to take Vector group test of Transformer?
- 16 Answers
- 96401 Views
- Sunflag Steel, Zuari Cements, I also Faced
- E-Mail Answers
Answer Posted / ponnudura
can anyone say me hoe to draw vector group and what is the
use of different vector group and its application plz
Is This Answer Correct ? 17 Yes 8 No submit
srinivas
Answer
# 8 1.1U1V1W-which is primary -Delta Connection
2.2U2V2W- Which is secondary-Star connection
3.join 1U& 2U terminals
4.Supply 1U-1V-1W 440v Measured
a.1U-1V
b.1V-1w
c.1W-1U
d.1W-2W
e.1V-2W
f.1V-2V
g.1W-2V
h.1U-2N
i.1V-2N
TO CHECK
1.1V-2W=1V-2V
2.1W-2V>1W-2W
3.1U-1V=1V-2N+1U-2N
From above check(1,2) the vector group of transformer is
verified
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to define tell me about self
why need to be maintain power factor for industrial customer?
How is magnetic leakage reduced?
75 kw motor take 45 amp in no load delta in star 10 amp but in load it will take 160 amp but IR velue of winding above 500 at 1kw ph to earth and ph to ph. what problem it should be?
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
Who are the manufacturer for Nitrogen based Fire Protectio/explosion prevention for Oil Filled Transformers? India and international both?
What is the size of a 60 watt and 80 watt tubelight?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
what shoud be strength and weakness to impress interviewer????????
How we calculate DC inducation moter Amp? Sir pls give me formula......
salam&hi, i need to know about how can i calculate an enough current for the new building before i submit it to the suppliers
Please define ohm’s law for a.c (alternating current)?
please suggest some good universities with low cost iam in totally full confusion so please help me my profile gre 283 and ielts 5.5
How much dc volt applied in cathodic protection system?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
