what is the use of capacitor in online ups?
- 6 Answers
- 17530 Views
- Emerson, ups, I also Faced
- E-Mail Answers
Answer Posted / rakeshkumar1017
there are two capacitor which are use to following.
1:- Reduce the harmonic loss.
2:-AC and DG cap use pure filtration of AC & DC supply.
3:-AC Cap use for PF control
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
which type of cabel
A jet of fluid strikes a plate What was the force required to counter it?
List the advantages of star-delta starter with induction motor?
Can you explain about pole discrepancy scheme
how to convert lv line to hv line and viseversa, any losses will occur during this process
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
what is the difference between the characteristics of two different phase bushing of any transformer
How can we select suitable capacity generator for three phase load (inductive load) and how to take study analysis in 3 three phase load system ?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
how diside ct mf exmp.200/5 ct
what are factors to be consider to design a HT & LT motor?
