how to check the earth resistance value& what is the
minimum earth resistance for good earthing sysytem.
- 33 Answers
- 144744 Views
- Brookfield, BSNL, DMRC, Epoch, KPTCL, Polycab, Power Control, SIEA, Siemens, Wipro, I also Faced
- E-Mail Answers
Answer Posted / nasir sharif
The earth resistance value can be checked by the use of
earth resistance tester (called megger earth tester). The
best earth resistance should be less than one ohm & ideally resistance is Zero ohm but the
permissible value is less than 5 ohm
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are IR values and what it should be for coil and for insulator
Whether amorphous core transformer is available in India?.If available then up to what rating of voltage and KVA?.
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
what is High resistance grounding and whatis the criteria for the selection of High resistance grounding
How does a tertiary winding filter harmonic(espcially 3rd one) from entering into load system?
explain why core loss of a transformer is almost constant under different load conditions when connected across a constant voltage and constant frequency.
What is the distance between each insulator in 33kv transformer and how can it calculate
plz tell me,ht and lt panel terminals in substations explain beiefly
Explain about Dubai electrical sysaem? Explain about Dubai drinking water system? Explain about Dubai Burj tallest building Electrical,Water.etc.. maintenance system?
Why do we mostly prefer to generate and distribute electricity in 3 phase and not in 4 phase or 5 phase?
would the same effect be achieved by reversing the connection to one winding of the induction motor 3-phase?
explain which quantities change in the starting and the and the running condition in induction motor
I have motor of 3 H.P. How i found the rating of capacitor use in it in single phase motor..???
Why do we need interlocking in a HT metering or Ring main unit switchgear?
How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?
