Interested to Buy Any Domain ? << Click Here >> for more details...
Where should we terminate the shield and why?
- 3 Answers
- 5709 Views
- OPaL, I also Faced
- E-Mail Answers
Answer Posted / raja2016
Thanks to Carl_ellis...
you almost enlightened the purpose of shielding and its function....
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
NSV type probe stands for
Draw symbols of the following :
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
What is 3 element control system
How servomotor controls throttle valve of TURBINE?
what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??
1.can you use SCADA instead of DCS,DCS instead SCADA 2.Difference between DCS and PLC,can their role be reversed i.e. role interchange 3.Difference between RTU and PLC
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
What is the use of double seated valve?
Explain the mechanism behind the turbine meter.
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
principle of dead weight tester ?
