Interested to Buy Any Domain ? << Click Here >> for more details...
how much % of steel use in footing, slab, column
- 18 Answers
- 157488 Views
- Bhel, Matrix, I also Faced
- E-Mail Answers
Answer Posted / engr.forhad
Piling -0.6 to 0.8%
Foundation -0.8 to 1%
Beam-1 to 1.5%
Slab- 0.8 to 1%
Column- 2 to 3%
| Is This Answer Correct ? | 1 Yes | 10 No |
Post New Answer View All Answers
why is M25 and Fe 500 assumed to be most economical? i feel it is not.This is because higher grade of concrete and steel has higher lapping length and anchorage length compared to lower grades..
at what pressure ply-wood is obtained by gluing wooden sheets
For the calculation of bearing pressure below the footing, to know whether it is below the safe bearing pressure of the soil, the unit of RCC below ground level to be taken is 25 KN/m3 or (25-15)KN/m3, where 25 is the unit weight of RCC and 15 is the unit weight of soil and whether the weight of backfilling to be taken?
what is idealized curve for concrere and steel
Formula for calculating the volume of bulb in underreamed pile
yasser arfatcompleted his degree in civil from which university
strength vs shape factor
Define What is diversion tunnel in a dam?
What is the coeffiencent Friction Angle between Steel and Ashphalt?
03. a. The water cement ratio for achieving maximum strength of concrete is…… 1 b. Water/ cement is inversely proportional to-------------- 1 c. Increasing the slump decreases the strength: True / false 1
Describe a time when you anticipated potential problems and developed Preventive measures
What things architect have to take care of before starting any project?
if a pipe those configuration (ASTM c 76 class b 450mm dia 2500mm length) fixing for water course those lining of water is 7000 running meter. my question is that if 8 joints of pipe ls leakage and we have not permission to stop the water so which treatment we apply on joint in that in condition.
percentage of metal,clay or soil & water in water bond macadam roads to know the quantities for each in total volume of 11500 cubic meters
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
