Interested to Buy Any Domain ? << Click Here >> for more details...
Hot calibrate a level transmitter (wet & dry legs)?
- 1 Answers
- 3729 Views
- Honeywell, IEC, I also Faced
- E-Mail Answers
Answer Posted / rajesh
Liquid with more boiling and freezing point in closed tank we need to select wet leg calibration.
Normal liquid for exp water in open tank we need to select dry leg calibration.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the importance of CV in the control valves? how it is calculated?
Explain the combusion chamber
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
draw the block diagram of a level transmitter ?
How is flow measured in square root?
Full form of KKS when use DCS.
anybody having Qatar Petroleum questions for instrument Technician offshore ....please send me
List three types Level Gauges with their working principles
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
what is sliding spool valves?
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
Lux meter is the measuring device to measure the lux level of lighting fixture. in industrial sector two types of lighting fixture is being used as street lighting purpose 1. HPSV (Sodium) and 2. HPMV (Mercury). HPMV having white light which is an combination of red, blue and yellow colour, while HPSV haivng Yellow lighting. in HPSV red & blue colour will be absent. during measurement of the lux level of HPSV and HPMV fixture. 1. Lux meter can measure the actual lux level of both fixture? 2. or it will show false reading for HPSV fixture light as it has only yellow light present. please give me answer
how to work MIL contol valve posistioner ?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?
