In a parallel circuit dc circuit with two resistors, if you
know the voltage, amperage, and one resistors ohms, what
formula is used to find the second resistors ohms?
- 6 Answers
- 6140 Views
- I also Faced
- E-Mail Answers
Answer Posted / shane e.
I1=Vt/R1
I2=It-I1
R2=Vt/I2
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
i want to know how to determine that a surge arrester work properly in 11kv system. and how to test a 12kv surge arrester
what is formula for zero phase sequence of nuetal earthing transformer of 6.6 kv
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
How to Calculate KA Rating of Main LT Panel
What are n circles?
How to find out damper winding failure for synchronous machine?
how flow current in 220 kv line to line
how to measure the transformer resistance values(dyn11)?and howmuch the minimum value?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
What should be the height of basement according to NBCC code?
What are the advantages of skewing of cage rotor conductors?
Explain about retrofitting of machine tool.
what is circuit breaker in transfomer and where it used
