Interested to Buy Any Domain ? << Click Here >> for more details...
Can i convert 230v ac to 24v dc by using a relay?Instead of
Smps is it possible?
What is relay logic in plc ??
How it works?
- 2 Answers
- 11861 Views
- Infotech, I also Faced
- E-Mail Answers
Answer Posted / sajjad khan
in PLC relay use only switching device'
i think using rectification convert 230 AC to 24 VDC
use 105400 volt PF and diodes and filter copacitor 220uf35 volt copacitor and Ziner Diode 24 volt 2 watt.
it's circuite is very simple and small.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
Why even multiple power supplu r used in instrumentation system?
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
what would be the minimum flow rate that we can measure on rotameter..?
SOME OF YOUR QUESTIONS ARE NOT MAKING ANY SENSE SO TRY AND PUT IN A LITTLE BIT MORE EFFORT BEFORE YOU POST A QUESTION. WE WILL ONLY HELP THOSE WHO WE CAN SEE ARE TRYING TO HELP THEMSELVES.
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
Can anyone convert a 5/2 way or 3/2 way valve into an ISO valve?
Explain the combusion chamber
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
what is RTV function in in process control?
Turbidity analyzer working principle ?
What is cut off relay? And why use in PLC and DCS?
