Interested to Buy Any Domain ? << Click Here >> for more details...
A circuit breaker on detecting fault will
a. Open
b. Close
c. Open and trigger the alarm
- 2 Answers
- 3493 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
While opening ,its auxiliary switches 1.open the trip circuit 2. make the closing circuit active 3. make the ' auto trip indicating lamp' on.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is the suitable transmission voltage?
WHat is the requirement of installing FAST ACTING EARTH SWITCH in GIS and how is that integrated with protection system. How and when does it operate?
Define maximum demand?
Why magnetic flux produces an induced current?? what is the detailed procedure ?? ans plz
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
What does ampere turns shows?
explain me the relation between torque, frequency,speed,voltage and current in the 3 phase induction motor?
after how many spot we must chang secondry cable in portable spot welding gun?
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
how can calculation ate Amps for cabel. Ex-for 1sqmm wire hou many amps we can draw
what is meant by impedance & transient protection?
What is the different between digital phase converter and ordinary phase converter?
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
how to find impedance , mutual indatnce in transmission lines
