Interested to Buy Any Domain ? << Click Here >> for more details...
how many testing use in power transformer?tell equipment
names?
- 2 Answers
- 5863 Views
- ABB, Electrical, I also Faced
- E-Mail Answers
Answer Posted / pradeep
There are so many testing are available to test a power transformer.
1. Turns ration testing : to ensure the no.of turns on each winding.
2. Winding resistance testing: To measure the resistance of each winding.
3. Vector group testing : To identify transformer vector group, which is very important for parallel operation.
4. Insulation resistance testing : To ensure the healthiness of transformer insulation resistance.
5. Impedance voltage testing : Important for parallel operation and loading condition assessment.
6. No load/ Short circuit testing : For the measurement of losses.
7. Partial discharge testing : To monitor the insulation imperfection/aging effect
8. Switching impulse/ lightning impulse testing : To measure the impulse withstand strength of the transformers.
9. Acoustic level measurement: To track the level of magnetic hum of the transformer.
10. Dissolved gas analysis: To identify dissolved gaseous in the transformer gases.
11. Dielectric testing : To measure break down potential of transformer oil.
And the count goes on...!!!
The type of testings carried out will vary based on the application and criticality
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How the over load setting for HT Motors calculated-provided in Numerical Relay
What is different between Circuit breaker and Isolater?
How would your past experience translate into success in this job?
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
difference between semiconductor & conductor & insulator?
What is the efficiency during maximum power transfer?
what is the purpose of using filters in a protective relaying scheme?
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
hello friends..... any one have papers or any study materials?sail ,hpcl...?
What is the meaning of Insulation H for transformers????
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
WHAT IS VCB SAFETY
