Why we use CT on differant phases of 2ph.PT detection for brush-less static excitation of 3ph.,400v Synchronous Generator?
What happen if use CT on same one of VT phase?
Post New Answer View All Answers
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
what is counter poise conductors
how will we calculate the copper wire load..
1.how many earth pits are required for 1000 k.w plant include substion , transformer ? 2. how many earth pits are required for 500kva generator.what is formula to calcute?
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
How to calculate LT XLPE CABLE for 11 kv / 433 v , 1000 kva oil type transformer system?
HOW TO CALCULATE S/C,O/C,E/F OF ACB.
300m long and 30kw inductive loade 3phase supply how many size cable required
what's the difference between abs/inc encoders. apart from the position remembrance what are all the other differences. and what's mean by grey code.
what is servo motor & how does it work.
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
how to compute kvar in substation feeder to improve power factor and sending voltage
What is the disadventage of gland earthing(power cable) if any. ?
Transmission through a short line depends on
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?