Interested to Buy Any Domain ? << Click Here >> for more details...
What should do when induction motor take more load in single phase ?
- 1 Answers
- 2628 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Most likely , there is inter turn short in that phase . When the number of turns is reduced , the back emf and the impedance are less resulting in more current to sustain the applied voltage.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is FM200 Gas??Applications........
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
what things to be considered when designing UPS
briefly explain principle of resistance welding
what is the IS foe lightning arrester?
Why Neutral Isolation is required?
In Indian Household, generally we receive 220V AC single phase supply. But AC has 2 phases, +ve & -ve. So in +ve half cycle current is flowing...so what happens in the -ve half cycle?? Please illustrate.
what are the range of memory address in plc for L&T lx7 4A
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
What is phenomenon of electromagnetic induction and how it works?
What type of fittings and electrical accessories can be install in radiation area ?
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
11 kV line deraction check by an Engineer.
if i am in front of transmission line how to know that current direction without any equipment
