Interested to Buy Any Domain ? << Click Here >> for more details...
125Kva Dg can take up how much amphere load.
- 7 Answers
- 39731 Views
- Indian Railways, I also Faced
- E-Mail Answers
Answer Posted / nadhan
Why should not we add the capacitor bank for dg set alternator to minimize the dgset load current.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
what is the voltages using in movie theaters??? why ??why not other??
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
mccb service sittings be done?
How will you justify IR value and Charging voltage of any motor,transformer and Cables.......???? . . . . . . . . Plz tell me any body Baljeet Singh, engineer_89@refiff.com
SIR, GIVE ME OPGW SAG CALCULATION FORMULA I AM DAE ELECTRICAL. THANKS
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
100 MVA 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase. what will be the fault MVA of generator.
Define damping ratio.
What is installed in PAC that is control the humidity
What is hipot test procedure?
how much excitation voltage required to generate 1mw power?
plz send me the procedure and syllabus for mseb exam
where was current transformer protection units used and why??
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
solar energy light efficiency & disadvantages?
