What is RTCC panel and why it is required
Answer Posted / viraj
As load increases or decreases according to that Tap of OLTC shoul be change for maintaining the voltage level of feeder,so RTCC(remote tap changer cabinet) will remotely operate OLTC.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
what is the voltage between earth & neutral in 3 phase electrical connection.
Why we find the sensitivity for the CT's to check?
How many lightning arrestors to be installed on 50MX60MX10M building and is there any formular for that?
Explain cos(theta) and Sin(theta)
What is the rating factor for copper cable ( Specific value according to the type of laying ) & the voltage drop?
How much weight an electrical engine can pull??
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
I want to do a mini project. Now I'm studying in 6th semis tor EEE Engineering.
a governer in an Ic engine controls the
what is meant by poly phase induction motor ? how its operating by single phase or three phase?
Z transform is use when system is not a) converges b) diverges
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
why the active power flow of some line is increased when the active power of out is cut ?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?