what do you mean by power factor ? in new view
Answer Posted / pradyumna171
It is the value of cosine angle between voltage and current due to inductive load (legging power factor) i.e the the value of cos 36 degree is 0.8 ( 0.8 cos fi ),cos 26 degree is 0.9 approx.(0.9 cos fi) and so on. It is also calculate by
True power/Apparent power,Resistance/Impedance or conductance/Admittance.here current leg behind voltage And in capacitive load that angle is minimized i.e improving the power factor.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Difference of induction motor & servo motor ??
how can we calculate the ratio of caustic soda and water in lrs.
How we can change the direction of rotation of Induction motor? Prove it using graphical
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
explain the mode of metal iranafer in Co,welding
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
WHat is the requirement of installing FAST ACTING EARTH SWITCH in GIS and how is that integrated with protection system. How and when does it operate?
Where burned of electricity,when,who, & why.
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
What are the section criteria for cables. Now everywhere XLPE power cable is used or PVC is also used?.
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
Please send 110 kv sb station full single line drawing(sld)
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
Who many reason of ignition fail ?