Interested to Buy Any Domain ? << Click Here >> for more details...
Should transformer earthing pit, to be connect to earthing
mat in Substation
- 4 Answers
- 10368 Views
- I also Faced
- E-Mail Answers
Answer Posted / nipesh
but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), in this case transformer body earthing and substation earthing both are joint through metal gland, is this safe for transformer and other equipment?
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to know vacuum in vacuum cylinder of breaker in working condition
Define demand factor?
How to select the proper VSD to operate high inertial load
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
What is touch potential and step potential?
I want to know all basics of electrical engineering
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
In the Variable Voltage Variable Frequency Drive, how the Voltage and Frequency varied ? Is it varied in the Inverter part of the Drive ? Please give us supporting document if any.
Is there any reason that we get shock on touching phase wire because the earth is at neutral potential? Is there any reason that the earth is at neutral potential because the neutral is earthed in apower station
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
why transmission is only 3 phase and not 2 or 4 or poly phases
what is frequency response?
How is the connection of the tap changer on the HV side been made?
What is Annunciation?
Why High voltage are generate noise ?
