Interested to Buy Any Domain ? << Click Here >> for more details...
what is the main purpose of reheater in a coal fired boiler
- 3 Answers
- 10861 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / ravi patel
reheater is used to maximum utilisation of heat energy (in form of temp) available at exhaust of turbine which cannot converted due to high (more than 12%) water content in water vapour (to minimise corrosion of turbine blades)
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
define fans and explain its types?
What is view factor ?
dear friends pls explain me what is meant by positive seal in solenoid operated valve
Can contractor purchase as cst purcbase who is registerd under wct act in mp
when do we use roller bearing, deep groove ball bearing, angular bearing, sealed bearing, semi sealed bearing, unsealed bearing, anti friction bearing, journal bearing, thrust bearing
What happen when too much cylinder oil is injected in the working cylinder?
How to report calorific values of fuel?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What type of pump is lubricator pump?
What is the purpose of stern tube?
what is mean by Hydraulic Overload in presses
Explain difference between fissile and fertile materials?
Identify or enumerate the parts of stern tube
CATIA:SPRING WITH SOME RADIUS AXIS
sir i am selected for HAL Ast. Engg so pls Interview Qus
