Answer Posted / furqan

In addition we also can not calibrate the pressure transmitter as equal to designed line pressure
calibrate the pressure transmitter on 80 percent of designed line pressure.

Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd

2111

---

How can you add value to this Industry if offered the job?

1587

---

What is 1:1 redundancy ?

2381

---

I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID

2787

---

please tell me what is a light up procedure of Cfbc boiler and what it's axuillaries of cfbc boiler?

8665

---

i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....

1463

---

HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.

2298

---

What is the cascade control

1418

---

in mass flow meter what is drive friquancy ?

2092

---

How to decrease opening & closing time of on/off valve?

1500

---

-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.

2450

---

What is the diffrence between ff tx and non ff tx

3183

---

Difference between ultra sonic flow meter

1993

---

i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.

2090

---

send me last 5 years questions asked in rrb chennai, for section engineer

2101

---