what is the difference between rise and tread? what is its
standered size? what is waist slab?what is the standered
length of staire-case? also what is the angle between floor
and landing?
Answer Posted / sivasubramanian
Tread is horizontal Portion and Riser is vertical portion.
Tread 10-12 inch & Riser 6-8 inch.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how gradation of aggregates effect on slump of fresh concrete?
for Precast foundation howmany days required we can shift the foundation with american Standards i need reference with section any body can help
find the discharge of water through a horizental venturimeter having 400mm dia at the inlet main and 150mm dia at thorat.if the diffrential gauge between inlet and thorat shows a pressure head of 25cm mercury. assume coefficient discharge 0.98 and specfic gravity of mercury as 13.6.
WHAT R THE GENERAL TECH QUESTIONS ASKED FOR THE INTERVIEW FOR AN AUTOMOBILE INDUSTRY,SPECIALLY DESIGN DEPT
Why we provide hair pin for shed
50 acre of land to be reclaimed for an average height of 2.5 mt. Dredging area is 500mx200m size. what is the dredging depth required to reclaim the area?
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
How do you convert wind speed into force?
How many % we consider for lap for reinforcement for estimates
What is the use of extruded feature in solidsworks?
What is difference between limit state and working stress method? How it is applies in building structure.
pile load testing procedure
what is differences between ferrock and concrete ?
How to fix toll charge for a particular vehicle at toll booths in a highway?
IS code for Rolling Margin of steel