Interested to Buy Any Domain ? << Click Here >> for more details...
How to connect field devices to PLC and DCS using a FIELD
BUS, DP,MOD BUS(please tell me any extra interfce or
adopters need in this case if we use remote i/o s)
- 3 Answers
- 17504 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajendra singh
first of all I want to tell you connection from field to DCS:
Example: C.V. to Tx. to controller via Ethernet cable to DCS.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What are the interlocks we have to check during the start up of LP/HP compressor?
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
what is the importance of CV in the control valves? how it is calculated?
Define cryogenic?
HOW TO SOLVE PROBLEM WITH ENRAF LEVEL TRANSMITTER 854 ATG THAT PASSWARD DO NOT Exist INTO TRANSMITTER TO ADJUST LEVEL WITH PORTABLE PET 847, WRITTEN WRONG PASSWORD , I AM SURE THAT DEFAULT PASSWARD (W2=ENRAF2) IS THIS TRANSMITTER NEED TO REPLACE SOFTWARE AND HOW?
what is metal of piston ring
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
Hi,can anyone help me out with PhD programs related to Instrumentation field?I have a degree in electronic Instrumentation?
Why humidity limit is 30 to 55 % for raw material storage?
What is the difference between ff transmitter and non ff transmitter
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
Calibration of controller (pneumatic)
what should he know if he is an assitent engineer instrumentation in cement industries of experience of 10 - 15 year.
field bus transmitter calibration procedure tell me
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
