Interested to Buy Any Domain ? << Click Here >> for more details...
When PRV operated at power transformer ,can anybody tell me particular pressure for 50mva transformer plzzz.
- 1 Answers
- 2606 Views
- BWSSB, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
PRV is provided to prevent tr from bursting due to the internal pressure . It could be from 0.4 Kg/cm2 to 4 Kg /cm2. The older tr s had explosion vent with copper foil
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is an Air COmpressor
An automatic water heater is an example of which type of control system?
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
it is in our knowledge tht right plug of supply of residential suppy system is phase n other is neutral...howevr the battery charger of mobile works in both ways...i mean it is not restricted in only one direction.ny of the holder of charger can hav phase .so y is it not lik tht phase of supply must b connected 2 phase of charger...?
What happens to voltage when current is zero?
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Y phase plates are used in transmission line??? what is there need???
why industry prefer ht motor instead of lt motor.
what happen ehen synchronisation is done at below rated speed
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
What is gain margin?
A logic circuit that provides a HIGH output if one input or the other input, but not both, is HIGH, is a(n)?
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
What is meant by full pitched winding?
