if we convert Ampers into kva,which one formula use by
us,pls tell me?
Answer Posted / dinesh jakhar
Apparent power =V.A
Unit of apparent power is VA or KVA or MVA
So if you want to find KVA simple formula u just need voltage and current
kVA= KV(voltage) * A (current)
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
it is in our knowledge tht right plug of supply of residential suppy system is phase n other is neutral...howevr the battery charger of mobile works in both ways...i mean it is not restricted in only one direction.ny of the holder of charger can hav phase .so y is it not lik tht phase of supply must b connected 2 phase of charger...?
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
Hi all I had applied for the RRB test in the ELECRICAL category. I would be pleased if any of you can sent me previous year question papers. Please forward the question papers to varshashahi@yahoo.com Thanks and regards Varsha
What are the different sign conventions used in electric circuits?
i have applied for junior engineer 2 c&w for Guwahati RRB please send me last five year question paper
1.what is the difference between ct and cvt? 2.what is the difference between pt and cvt? 3.what is the difference between relays and circuit breakers?
What is the effect of pd controller on system performance?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
What is the most accurate way of testing ELCB?ELCB is better than RCD?
what is the use of vcb & isolator in substation?
how to avoid Saturation in C.T?
what is magnetizing and demagnetizing current in generator and motor?
Why efficiency of generator is higher than motor at a particular load?