Interested to Buy Any Domain ? << Click Here >> for more details...
Can a pneumatic control valve work without positioner?
- 4 Answers
- 8459 Views
- SMC, I also Faced
- E-Mail Answers
Answer Posted / ajaya kumar behera
Yes we can only fully open/close by changing instrument air supply from header valve
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
WHAT IS TMXT IN TEMPERATURE FOUNDATION FIELDBUS.
i am having information technology branh ....... can i prepare for psu exam
Define the terms Accuracy, precission, Spam, process tolerance while doing calibration of an instrument? Explaini with an example?
Gas equation
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
What is the difference bitween control net scaner and device net scaner
I want to know the questions asked in ONGC interview(after being selected in the written exam) for Instrumentation branch.Kindly help.
How to Calibrate Interface Level Troll in field
any questions on motor and energy conversions machines?
Explain the mechanism behind the turbine meter.
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
what is the reason while warning lamp is on while the engine is cranking?
How to find out the current of two motors having same power consumption but different RPM?
