Interested to Buy Any Domain ? << Click Here >> for more details...
Difference in load break switch, isolator and circuit breaker.
- 1 Answers
- 3879 Views
- KSEB, L&T, Siemens, I also Faced
- E-Mail Answers
Answer Posted / jithendra
Load break switch (LBS) will operate on load only over current protection (FUSE) needs to replace the fuses
Isolater will operate for ON/OFF NO ANY TYPE OF protection
Circuit Breaker types 1.MCB 2.MCCB 3.ACB
1. trips for only over load.
2. trips for over load,short circuit.
3. trips for over load,short circuit,ground fault
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the effect of interchanging core(made of steel) and winding(made of copper) material in case of transformer? Give proper explanation in regard to different losses in transformer.
can i use the six sigma method which is used in management area, in state estimation of power systems?
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
What is the difference between DOL starter and star delta starter
11kv/433v delta/star distribution transformer primary side full load Ht current is 83.33A in , but input side VCB rating 800A.why?
EXPLAIN METOD OF IMAGE OF TRANSMISSION LINE/ WHAT ARE ITS PRACTICAL APPLICATION?
How can i get my certificate of competency as an electrical supervisor? I have complicated my B.Tech from Uttarakhand technical university this year (2012).
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI and secundrabad}}} TECHNICAL question papers TO MY EMAIL ID dinesh100701@gmail.com
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?
During Starter Panel Com missing I Found The Main Incomer 40Amp MCB 10KA Trip When Motor Change Star To Delta Motor Rating 20HP BUT When We Use Same MCB To Other Motor It Does Not trip Or What Is Necessaries for Star Delta Starter MCB SFU MPCB OR MCCB And What are The Breaking Capacity of MCCB in the Motor above 15HP
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
How to run a three phase motor into single phase........
Explain the different regions in frequency response?
11KV AND 22KV NETWORK KW CAPACITY IN RING AND RADIAL?
