What is the problem, if a circuit breaker is not closing.
- 4 Answers
- 18195 Views
- KSEB, L&T, Siemens, I also Faced
- E-Mail Answers
Answer Posted / shariq sultan
if u provide the drawing i shall guide u definatly. step by step
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is difference between earthingpits,earthing grid & earthing mess?
draw the restricted earth fault protection circuit install on power transformer and identify its parameters and draw C/C curve of it
Why temperature rise is conducted in bus bars and isolators?
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
what is the chiller and working principal
What is power in wattage of 8.5 TR AC
When will you multiply and devide with derating factors to the actual value while sizing the cable?
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
In convertor can we use rectifier thyristor in place of invertor thyristor with explain.
WE HAVE THE DC RECTIFIER 1500A, INPUT VOLTAGE IS 3 PHASE. HOW TO CALICULATE THE LOAD? 3 PHASE SIDE EITHER dC SIDE. PLEASE SUGGEST ME
How much no load current of synchronous motor
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
what r the checklist while installing a 380 kva DG set
How to calculate wire length,size & current? ( related to control panel)
