How to do manual mapping in radar type level transmitter?
Answer Posted / d chinna babu
Manual mapping will be done when radar gives wrong reading due to obstacles in reactor.For Eg if it is showing 15% level due to some obstacle the distance more than 15% should be entered in manual mapping to delete the error.
But mapping will not work for more than 20%
Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
how many types of viberation transmitter and how to calibrate and where use of vibration transmitter
Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
what effects a surging can produce in the compressor
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
Explain pH, Conductivity.
Calibration procedure for Electro magnetic Flow meter
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
what is the difference between active & reactive power?
Where is wet leg is used?
i need some objective type questions in instrumentation
What are different types of cable?
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com