What is purpose of APFC panel?
Answer Posted / nizam
Automatic power factor correction is used to improve power factor, number of capacitor is connected through relay when pf is low then relay is pickup and connect the capacitor.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how can i improve the power factor in domestic (230v)
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz
What are the various kind of cables used for transmission?
How to Make relay co ordination chart for a Electrical power distribution of a plant
what is the thumb rule for determination resistance of resistor?
Use of switch mode power converter in real-time basis?
what happens to the supply voltage if there is any change in frequency?
What is resonant peak?
5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch
Why two phase welding machine is used instead of three phase welding machine.
What is VCB? where it is installed at SP. What is SP?
What are the advantages and disadvantages of the dc motors?
What’s electric traction?